How To Install Catch Can On F150 Ecoboost
Installing a take hold of tin can will assistance your engine breathe a little better. A catch can removes all of the toxic, oil, fuel and condensation mixture out of circulation. Keeping a cleaner intake and intercooler. Here is a guide by the guys who made the UPR catch tin can bachelor for our trucks.
1. The installation requires you lot to elevator the wire harness off the stud on the driver side fan shroud stud.
two. And so remove the fan shroud stud and position the grab can in place then re-install the stud and wire harness.
three. Important tip is to keep the screws on the top of the catch tin can loose then you can rotate the can to relax the lines.
4. Next you will remove the passenger side PCV hose that runs from the valve comprehend to the intake manifold by the throttle trunk.
5. Now you will run the muddied side line from the summit of the catch tin to the passenger side valve cover. (5/8 line with no check valve)
6. Now you lot will run the clean side line from the side of the catch can to the rider side throttle body. (5/8 line with check valve closest to the catch tin)
vii. Next y'all will need to remove the driver side line with the EPS sensor and install the UPR one way EPS sensor line in identify.
8. Lastly you lot will install the short line for the WOT connexion from the quick connector on the EPS to the driver side of the catch tin can.
9. Now you tin tighten the bolts and lock the tin in identify and double cheque all your connections
10. Offset your engine let it idle and walk around and check everything one last time and your all gear up.
Source: https://f150ecoboost.com/blogs/upgrades/catch-can-install-upr-dual-valve-on-a-2015-f150-ecoboost-3-5l
Posted by: hatchergooned1961.blogspot.com
0 Response to "How To Install Catch Can On F150 Ecoboost"
Post a Comment